The design of nuclear facilities is based on the principle of “Defence in Depth”, which leads to the implementation of successive defence levels (intrinsic characteristics, material provisions and procedures), intended to prevent incidents and accidents, and then, if the preventive measures fail, to mitigate their consequences. Radioactive substances are contained by the positioning of three containment barriers between these substances and the outside environment: ∙ the cladding around the fuel rods retains the radioactive products contained in the fuel pellets; ∙ the primary system, which constitutes a second envelope capable of retaining the dispersal of radioactive products contained in the fuel if the cladding fails; ∙ the containment, which is the concrete building housing the primary system. In the event of an accident, it is designed to contain the radioactive products released by a failure of the primary system. 1.3 THE CORE, FUEL AND ITS MANAGEMENT The reactor core consists of fuel assemblies made up of “rods” comprising “pellets” of uranium oxide or depleted uranium oxide and plutonium oxide (for Mixed Oxide – MOX fuels), contained in closed metal tubes, called “cladding”. When fission occurs, the uranium or plutonium nuclei, said to be “fissile”, emit neutrons which in turn trigger other fissions: this is the chain reaction. The nuclear fissions give off a large amount of energy in the form of heat. The water in the reactor coolant system, which enters the lower part of the core at a temperature of about 285°C, heats up as it rises along the fuel rods and comes out through the top at a temperature of close to 320°C. At the beginning of an operating cycle, the core has a considerable energy reserve. This gradually decreases during the cycle, as the fissile nuclei are consumed. The chain reaction and thus the power of the reactor is controlled by: ∙ the insertion of “control rod clusters”, containing neutronabsorbing elements, into the core to varying extents. This enables the reactor’s reactivity to be controlled and its power adjusted to the required production of electricity. Gravity dropping of the control rods is used for emergency shutdown of the reactor; VVP EAS RCV NUCLEAR ISLAND Separator Superheater Condenser Generator Secondary system Steam Generator Reactor vessel Control room Primary system RRA Fuel pool ARE TEP RIS RRI SEC Water course Reactor coolant pump Pressuriser PTR Reheater ARE: Feedwater Flow Control System ASG: Steam Generators Auxiliary Feedwater System EAS : Reactor Building Containment Spray System PTR : Reactor Cavity and Spent Fuel Pit Cooling and Treatment System RCV : Chemical and Volume Control System RIS : Safety Injection System : Exchanger RRA: Residual Heat Removal System RRI: Component Cooling System SEC: Essential Service Water System TEP: Boron Recycle System LP or HP turbine: Low-Pressure or High-Pressure Turbine VVP: Main Steam Systems : Pump CONVENTIONAL ISLAND LP Turbine LP Turbine HP Turbine Pressurised water reactor operating principle ASN Report on the state of nuclear safety and radiation protection in France in 2023 291 • 10 • The EDF Nuclear Power Plants 10 05 15 08 11 04 14 06 07 13 AP 03 02 09 12 01
RkJQdWJsaXNoZXIy NjQ0NzU=